In Windows, Mapped drives are only accessible by the user that is logged in when the drives are mapped. Net use S: \\10.10.42.50\plindqui /USER:10.10.42.50\plindquiĬan enyone explain in simpler words this. The raw command is this (replace contents inside angle brackets and remove the angle brackets): Without the IP (or desktop name if Windows) it does not work. The key element of the net use command is the /USER:ip\username syntax. It is highly likely, however, that you'll get answers if you post in the support forum. If you do not feel comfortable using a command-line, you should stop now.ĬrashPlan support is not able to respond to questions about Windows mapped drives. This method for backing up a mapped drive requires an advanced level of knowledge with Windows. ![]() ![]() It is not supported by CrashPlan so proceed at your own risk. If you would like to back up a mapped drive on Windows, this article describes an unofficial method for doing so. This is an OS level restriction built into Windows. I guess i need some help following these steps outlined in this article:ĬrashPlan does not support backing up mapped drives on Windows.ĬrashPlan runs as a Windows service and therefore cannot access drives mounted by a user.
0 Comments
Leave a Reply. |